Garage Door Weather Seal Replacement

The weather seals are the flexible strips that close the gaps around a closed door: a rubber bottom seal under the lowest section, and vinyl or brush weatherstripping along the sides and top of the frame. They keep out rain driven by wind, dust, leaves, insects, and rodents, and they cushion the door's landing on the floor. Bottom seals fail by flattening, cracking, and tearing at the corners where they drag; rodents chew them at the ends; and a seal that has gone hard no longer compresses, so daylight shows under the door and water walks in across the slab. Side and top seals crack and curl away from the door face with age and sun. Replacement of the bottom seal starts with identifying its profile: most slide into an aluminum retainer under the bottom section as a U-shaped or T-shaped strip, and the new seal must match the retainer's channel or it will pull out as the door moves. The old seal is slid or pulled out, the retainer channel is cleaned of the grit and old seal fragments packed into it, and the new seal is fed through, cut with a small allowance for shrinkage, and its ends tucked so they do not catch the frame. Where the retainer itself is bent or corroded, it is straightened or replaced so the seal sits flat. Side and top weatherstripping is fitted to the frame with the door closed, set so the flexible lip rests against the door face along its whole length without pressing hard enough to drag or to hold the door off its seal at the floor. Afterward the door's closing is checked: the opener's down limit and force are adjusted if needed so the bottom seal compresses evenly from end to end, and the closed door is checked from inside in daylight, where any remaining gap announces itself as a line of light.

Free EstimateCall (888) 248-0203