Garage Door Track Repair
The tracks guide the door, and track repair corrects the bends, shifts, and looseness that make a door bind, scrape, or climb out of alignment. Damage usually comes from impact, such as a bumper, a mower, or a ladder swung in a tight garage, or from brackets that have worked loose in the framing until the track drifts out of plumb. The signs are a door that shudders at the same point in every cycle, fresh scrape marks on a section edge, rollers that ride hard against one side of the channel, and a gap between the door and the frame on one side when closed. Repair begins with the door secured and the opener disconnected, and with measuring rather than eyeballing: the vertical tracks are checked for plumb, the horizontal tracks for level and for equal height where they meet the curve, and the spacing between track and door edge is compared top to bottom on both sides. A track should hold the rollers with a small, even amount of play, tight enough that the door seals against the frame, loose enough that the rollers roll instead of dragging. Bends that have only deflected the steel can be worked back to profile, and the channel is checked afterward with a roller rolled through it by hand. Brackets are re-anchored into the jamb framing with the correct lag screws, never just snugged back into the same stripped holes, and the flag brackets at the curve, the pieces that join the vertical track, horizontal track, and spring shaft hardware, are checked for cracks where they carry the load. Where the door's problem turns out to be a symptom, such as a cable off its drum pulling the door sideways or a bent section forcing the rollers, that cause is corrected too, because a realigned track will not hold its settings against a door that is being pulled crooked. The door is then run slowly through its full travel and watched at the point where it used to bind.
