Garage Door Spring Replacement

The springs do the actual lifting on a garage door; the opener only guides a door the springs have balanced. Most residential doors use one of two systems. Torsion springs mount on a shaft above the door and wind up as the door closes, storing the energy that lifts it on the way back up. Extension springs mount alongside the horizontal tracks and stretch instead. A spring breaks from cycle fatigue: every open and close is one cycle, and standard springs are rated around ten thousand cycles. The break usually announces itself with a sharp bang and a visible gap in the coil, and the door then becomes dead weight that the opener cannot and should not lift. Replacement starts with identifying the correct spring, and that is a measurement, not a guess: wire gauge, inside diameter, coil length, and wind direction together determine how much torque a torsion spring produces, and the spring is matched to the door's weight and height. A spring that is too weak leaves the door heavy; one that is too strong makes it fly up and strain every other part. On a two-spring torsion system both springs are replaced together even when only one has broken, because the survivor has used the same number of cycles. The work is done with the door down and secured, the new springs slid onto the shaft, and tension applied with winding bars in quarter turns counted against the door's height. Extension springs are replaced in pairs the same way, with their safety cables refitted through the new springs. Drums, cables, the center bearing, and the shaft are inspected while the system is apart. The job ends with the balance test: disconnected from the opener, the door should lift with modest effort, hold at mid-travel without drifting, and settle closed without slamming.

Free EstimateCall (888) 248-0203