Garage Door Roller Replacement

The rollers are the wheels that carry the door in its tracks, one at each hinge point along both sides, and their condition decides how a door sounds and feels more than almost any other part. Builder-grade rollers are plain plastic or steel wheels on a stem with no bearing at all, and they wear oval, develop flat spots, and rattle in the track. Better rollers carry ball bearings, commonly seven or ten to a wheel, and nylon-tired versions run the quietest because the tire, not bare steel, contacts the track. A door that rumbles, shudders, or pops as it travels, and rollers that wobble on their stems or refuse to spin when flicked, are ready for replacement. The stems are also checked for scoring where they ride inside the hinge tubes, because a scored or bent stem drags and clicks even when the wheel itself still turns. The work is done with the door down. Rollers are changed one hinge at a time by easing the stem out of the track or removing the hinge, so the door is never left unsupported, and the track is wiped clean of the grit and dried lubricant that grind new rollers down. The rollers at the bottom corners get special handling: they sit in the bottom brackets, which are under full cable tension, so those brackets are never unbolted casually. The door is secured and the tension dealt with first, or the roller is worked out of the bracket without disturbing its fasteners. Stem length and wheel diameter are matched to the track; residential doors use two-inch wheels in two-inch track, and mixing sizes makes a door ride loose or bind. After a full set is fitted, the door is run by hand and then under the opener, and the change is usually obvious in the first cycle: the door tracks smoothly through the curve, the rattling stops, and the sections stop chattering against each other as they articulate.

Free EstimateCall (888) 248-0203