Garage Door Panel Replacement

A damaged section, most often the bottom one and usually from a vehicle, can often be replaced on its own instead of replacing the whole door, provided the door's model and panel profile are still available. Matching is the first question. Sections are stamped in specific raised or recessed patterns, in specific widths and thicknesses, with specific tongue-and-groove edges where they meet the next section, and a section from a different model will not seal or articulate correctly even if it measures the same. The existing door is identified by its model, size, and profile, and the replacement section is ordered to match, with the honest caveat that finish and color on a new section rarely match a door that has weathered several seasons in the sun. The work is done with the door closed and the opener disconnected. Sections are unstacked from the top down to reach the damaged one, or the damaged section is worked out in place where its position allows, with rollers and hinges transferred or renewed as each section is handled. Window inserts and decorative hardware are moved to the new section, and on wide doors the reinforcement strut that keeps the section from flexing is refitted across its full width. The bottom section carries extra hardware: the bottom brackets, which hold the lift cable anchors, and the bottom seal retainer. A bottom-section replacement therefore includes transferring the brackets, refitting the seal, and re-checking cable tension and door level afterward. If two or more sections are damaged, or the tracks and frame took the same hit, that is reported plainly, because section-by-section replacement stops making sense against the condition of the whole door. The finished door is run through its full travel to confirm the new section articulates through the curve and seals against its neighbors without gaps or rubbing.

Free EstimateCall (888) 248-0203