Garage Door Keypad Installation

A wireless keypad mounts outside the garage and opens the door with a personal identification number instead of a remote, which makes it the entry method for family members, dog walkers, and anyone who arrives without a transmitter in hand. The keypad talks to the opener by radio, so before anything is mounted the keypad has to match the opener's radio system: its frequency, and whether it uses fixed codes or rolling codes that change with every use. Most current openers use rolling-code systems, and a keypad built for an older fixed-code unit will not pair with them, whatever the packaging suggests. Compatibility is confirmed at the opener's learn button and model plate first. Programming follows the opener's learn sequence: the opener is put into learn mode, the new PIN is entered and confirmed, and the keypad is tested several times from outside before it is screwed down. Most keypads also allow a temporary PIN that can be given out for a single day or a limited number of uses and then expires, which suits deliveries and house guests. Mounting is on the door frame or the wall beside the door, at a height children can reach but weather cannot pour into, with the flip cover closing over the keys to keep rain and sprinkler spray off the pad. The keypad runs on a battery, usually a 9-volt or a pair of AAs depending on the model, and a weak battery is the first suspect when a working keypad starts needing the PIN entered twice. After installation the PIN is changed from any factory default, codes belonging to previous occupants are cleared from the opener's memory where the household asks for it, and the door is tested for one-touch closing where the keypad supports it. Where a household runs two doors, many keypads hold a separate PIN for each opener, and both doors are programmed and tested from the one pad before the visit ends.

Free EstimateCall (888) 248-0203