Garage Door Hinge Replacement

The hinges do two jobs on a sectional garage door: they join the sections so the door flexes as it rounds the curve of the track, and the end hinges carry the rollers that ride in the tracks. The end hinges are graduated, stamped with numbers that increase up the door, and each number holds its roller a slightly different distance from the door face, which keeps the sections parallel to the track as the door travels. The center hinges simply link the sections at their stiles. Hinges fail by cracking across the knuckle, by screws working loose and elongating their holes in the stile, and by wear that lets a section sag and rub its neighbor. The signs are a door that pops or cracks as it moves, sections that no longer sit flush, daylight showing between sections, and fresh rub marks on the panel faces. Replacement is done with the door fully down and supported, one hinge at a time, so the section alignment is never lost. The new hinge must match the number and gauge of the one removed; fitting a number-one hinge where a number-three belongs throws the roller geometry off and makes the door bind in the curve. Where screw holes in the stile are torn out, longer fasteners or a repair plate give the new hinge solid material to bite into, and a stile that is split or crushed is reported, since no hinge will hold in failed steel or wood. Roller stems are checked as each hinge comes off, and a roller with a worn or wobbly stem is dealt with while it is out. After the set is fitted, the door is run by hand through the curve to confirm the sections articulate smoothly, sit evenly when closed, and show no new rub marks along the panel faces.

Free EstimateCall (888) 248-0203