Garage Door Cable Repair

The lift cables are what actually connect a garage door to its springs. On a torsion system each cable anchors to the bottom bracket of the door, runs up alongside the track, and wraps onto a grooved drum at each end of the spring shaft. On an extension system the cables run over pulleys at the front of the horizontal tracks. When the spring turns the shaft, the drums wind the cable in evenly and the door rises level. Cable trouble shows up as a door that sits crooked when closed, one side lagging as it opens, a frayed or fuzzy cable where strands have broken, rust streaks near the bottom bracket, or a cable that has jumped off its drum and tangled into a bird's nest of wire. A cable that has slipped off the drum can sometimes be reseated: the door is secured, spring tension is wound off in a controlled way, the cable is untangled and laid back into the drum grooves, and tension is reapplied evenly to both sides so the door lifts square. The reason the cable jumped is part of the repair. A worn drum with a flattened groove, a bent track, or a door that was run while an obstruction sat under one side will throw a cable again if only the cable is corrected. Frayed or rust-stretched cables are not spliced or patched; a cable with broken strands has lost strength and is replaced, and cables are changed in pairs so both sides carry equal stretch and age. Bottom brackets are inspected at the same time, because the cable anchor point is also where rust attacks the bracket and the lower edge of the bottom section. All of this work happens with the spring under load, so the door is clamped and the tension is handled with winding bars, never by pulling the cable by hand.

Free EstimateCall (888) 248-0203